TendoMat®
Electric fence winder
Wind and unwind fencing wire without the usual effort
With the TendoMat®, painstaking, time-consuming, and tiring winding and unwinding of fencing wire is now a thing of the past. Fitted quickly and easily to a tractor, all-terrain vehicle, car trailer or quad bike, even large areas of farmland can be fenced in record time (2 ha in just 20 min) – without muscle power.
Equipment features of the TendoMat®:
- 12 V electric motor for unwinding (bottom reel) and winding (top reel) the wire
- Metal parts of non-rusting stainless steel
- Slip clutch for overload protection
- 2 aluminum wheels (Capacity: approx. 2 km wire length each with 2.5 mm wire), battery and control cable included in delivery
- Control panel as standard
Technical data
Dimensions (LxWxH): | 770 x 380 x 900 mm |
Motor power: | 100 W |
Fuse: | 25 A |
Winding speed: | ca. 80 – 130 m/min |
Speed range: | approx. 70 – 136 U/min |
Power consumption: | Normal operation up to 18 A |
Operating temperature: | -10 to +50 °C |
Storage temperature: | -30 to +50 °C |
Battery cable: | 5 m (2.5 mm²) |
Control cable: | 6 m |
Special features of the TendoMat®
Control panel as standard The control panel for switching on/off and selecting a fast/slow winding speed is included with every TendoMat®.
12 V operated With the TendoMat® wires up to 1 km long (depending on wire diameter) can be pulled directly out of the fence posts and wound back up.
Downloads
Brochure
TendoMat®
0.8 MB
Accessories
Battery cable with bracket (1x as standard)
Cable length 5 m. If you need a 12V supply on a further carrier vehicle, then we have the right battery cable with control panel bracket for this. Important: With each LEHNER spreader a battery cable with bracket is included in the scope of delivery.
Aluminum replacement reel
The TendoMat’s scope of delivery includes two aluminum reels. Replacement reels, Ø 350 mm, are optionally available.
Trolley
Trolley for easy parking and transport of the spreader. Dimensions (LxWxH): 60.5 x 30.5 x 14.5 cm
Brackets
Drawbar coupling holder, foldable (fits for 70 to 170 l)
Thanks to multiple installation holes, this attachment can be mounted on almost any wheel loader or forklift truck. Bolt diameter: 36 mm. It simplifies access to the tailgate without removal of the spreader. The holder is stabilised and braced to the carrier vehicle by the 4x M20 levelling legs with swivel feet.
Holding device for tailboard
By means of the tailboard holding device, the spreader is easy to attach to a straight, unbent tailboard, and is fixed using two set screws.
Spare wheel bracket
The spare wheel bracket is intended to attach the spreader to an all-terrain vehicle, at the position on the rear door where the spare wheel is normally located. For this, one hole has already been made by the vehicle manufacturer; please drill two more according to the hole pattern for your vehicle. The four holes for attaching the spreader have already been provided by the manufacturer.