TendoMat®
Electric fence winder
Wind and unwind fencing wire without the usual effort
With the TendoMat®, painstaking, time-consuming, and tiring winding and unwinding of fencing wire is now a thing of the past. Fitted quickly and easily to a tractor, all-terrain vehicle, car trailer or quad bike, even large areas of farmland can be fenced in record time (2 ha in just 20 min) – without muscle power.
Equipment features of the TendoMat®:
- 12 V electric motor for unwinding (bottom reel) and winding (top reel) the wire
- Metal parts of non-rusting stainless steel
- Slip clutch for overload protection
- Battery and control cable included in delivery
- Control panel as standard
Technical data
Dimensions (LxWxH): | 770 x 380 x 900 mm |
Motor power: | 100 W |
Fuse: | 25 A |
Winding speed: | ca. 80 – 130 m/min |
Speed range: | approx. 70 – 136 U/min |
Power consumption: | Normal operation up to 18 A |
Operating temperature: | -10 to +50 °C |
Storage temperature: | -30 to +50 °C |
Battery cable: | 5 m (2.5 mm²) |
Control cable: | 6 m |

Special features of the TendoMat®

Control panel as standard
The control panel for switching on/off and selecting a fast/slow winding speed is included with every TendoMat®.

12 V operated
With the TendoMat® wires up to 1 km long (depending on wire diameter) can be pulled directly out of the fence posts and wound back up.
Downloads
Brochure

TendoMat®
0.8 MB
Accessories

Battery cable with bracket (1x as standard)
Cable length 5 m. If you need a 12V supply on a further carrier vehicle, then we have the right battery cable with control panel bracket for this. Important: With each LEHNER spreader a battery cable with bracket is included in the scope of delivery.

Stainless steel replacement reel
The TendoMat’s scope of delivery includes two stainless steel reels. Replacement reels, Ø 350 mm, are optionally available.

Trolley
Trolley for easy parking and transport of the spreader. Dimensions (LxWxH): 60.5 x 30.5 x 14.5 cm
Brackets

Bracket for lawn mower tractor
The upper pipe is mounted in place of the hopper, while the lower pipe is clipped onto the springs. Generally, the support still has to be adapted to the carrier vehicle; it is not suitable for every type of tractor without some adjustment.

ATV/quad holder “Rear”
This holder is attached to the steel luggage carrier of an ATV or quad, and thanks to its design it ensures a low centre of gravity for the vehicle.

Drawbar coupling holder, foldable (fits for 70 to 170 l)
Thanks to multiple installation holes, this attachment can be mounted on almost any wheel loader or forklift truck. Bolt diameter: 36 mm. It simplifies access to the tailgate without removal of the spreader. The holder is stabilised and braced to the carrier vehicle by the 4x M20 levelling legs with swivel feet.