The TendoMat™ can be run with a tractor, off-road vehicle or ATV thanks to its 12-volt motor.
This also allows for ready use on difficult terrain without any major restrictions.
For all add-on components, a screw set for fixing them in place is standard.
The following supports are available to you as add-on components: |
Side panel support
With the side panel support, the TendoMat™ can be mounted effortlessly into the side panelling and fixed in place by means of two adjusting screws.
|
 |
|
KAT 0, KAT I, KAT II three-point linkage
This is used for mounting the hydraulics to the upper and lower links.
It can be mounted in the front or rear.
Dimensions:
KAT 0: 530 mm
KAT I: 683 mm
KAT II: 825 mm
|
 |
|
Pick-up support
The height of the pick-up support is adjustable. The distance from the tailgate upper edge to the upper edge of the hitch ball is adjustable from 590 to 780 mm.
Vehicles checked so far:
Ford Ranger 700 mm, Nissan Narara 760 mm, Isuzu/Opel Campo Sports Cab 735 mm, Mitsubishi L200 735 mm, Dodge RAM 740 mm (hitch far behind), Landrover 830 mm (is too big)
|
 |
ATV/Quad support "rear"
This support is fixed in place to the steel luggage carrier of an ATV or quad and, thanks to its construction, provides for a deeper centre of gravity of the vehicle. |
 |
Spare tyre holder
The spare tyre holder is intended for attaching the TendoMat® to off-road vehicles that normally have a replacement tyre hanging on the rear door. A hole is drilled at the factory for this purpose. Please drill two others according to the hole locations of your vehicle. The four drilled holes for mounting the spreader are already provided for at the factory. |
 |
| |
Mounting it onto a trailer has proven advantages. In this way, the posts can be carried along as well. Also when using a pick-up, there's a large enough loading area to store a sufficient amount of posts.
|
