The POLARO® can be mounted on the front or rear of all vehicles. There are mounting drill holes on the rear and bottom of the frame.
For all add-on components, a screw set for fixing them in place is standard.
As mounting supports, we offer the following mounting options for our POLARO®:
|
Side panel support
With the side panel support, the POLARO® can be mounted effortlessly into an even, unbent side panel and fixed in place by means of two adjusting screws.
|
 |
KAT 0, KAT I, KAT II three-point linkage
This is used for mounting the hydraulics to the upper and lower links.
It can be mounted in the front or rear.
Dimensions:
KAT 0: 530 mm
KAT I: 683 mm
KAT II: 825 mm
|
 |
Towing hitch support
(for wheel loaders, forklift trucks, etc.)
This universal support is stuck into the towing hitch in the rear. The bolt diameter measures 28 and 32 mm, respectively, as a standard (over thrust sleeve). The support is stabilised via the lateral angle and braced on the swivel feet with adjusting screws.
(See POLARO® customer pictures)
|
 |
Adjustable feet for fixing in place the towing hitch support
JDepending on the form of the towing hitch and rear of the towing vehicle, either two or four adjustable feet may be needed, or none at all.
(See POLARO® customer pictures) |
 |
|
Pick-up support
The height of the pick-up support is adjustable. The distance from the tailgate upper edge to the upper edge of the hitch ball is adjustable from 590 to 780 mm.
It can be used for a side panel width of up to 70 mm.
Vehicles checked so far:
Ford Ranger 700 mm, Nissan Narara 760 mm, Isuzu/Opel Campo Sports Cab 735 mm, Mitsubishi L200 735 mm, Dodge RAM 740 mm (hitch far behind), Landrover 830 mm (is too big)
|
 |
ATV/Quad support "rear"
This support is fixed in place to the steel luggage carrier of an ATV or quad and, thanks to its construction, provides for a deeper centre of gravity of the vehicle. |
 |
Spare tyre holder
The spare tyre holder is intended for attaching the POLARO® to off-road vehicles that normally have a replacement tyre hanging on the rear door. A hole is drilled at the factory for this purpose. Please drill two others according to the hole locations of your vehicle. The four drilled holes for mounting the spreader are already provided for at the factory. |
 |
Support for lawn mower tractor
The upper pipe is mounted in place of the catch, the lower pipe is clipped onto the springs.
(The support must generally still be adjusted to the towing vehicle; it is not suitable for every tractor type without modification) |
 |
|
