The VINERO™ can be mounted on the front or rear of all vehicles. There are mounting drill holes on the rear and bottom of the frame.

For all add-on components, a screw set for fixing them in place is standard.
As mounting supports, we offer the following mounting options for our VINERO™:

3-point linkage hitch mounting support The 3-point linkage hitch is fixed in place with four screws. The spreader can thus be effortlessly mounted onto the 3-point linkage hitch and removed again without any tools.
KAT 0, KAT I, KAT II three-point linkage This is used for mounting the hydraulics to the upper and lower links. It can be mounted in the front or rear. Dimensions: KAT 0: 530 mm KAT I: 683 mm KAT II: 825 mm
Standard cultivator support With this support, the SuperVario® is built onto a cultivator for the rational spreading of catch crops. For this, it is fixed in place with four screws. When spreading catch crops, we recommend mounting the spreader directly onto the soil-tilling implement. It should be mounted such that the spreading material falls into the rollers or the freshly tilled soil after the device.
Cultivator support for 3-point linkage hitch In combination with the 3-point linkage hitch mounting support, this support provides for maximum comfort while spreading. No tools are necessary to switch between mounting on the cultivator and using the spreader in the front.
Front towing hitch support This universal support is stuck into the front towing hitch. The bolt diameter measures 28 and 32 mm, respectively, as a standard (over thrust sleeve). The support is stabilised via the lateral angle and braced on the swivel feet with adjusting screws. (See POLARO® customer pictures)
Adjustable feet for fixing onto the front towing hitch support Depending on the form of the towing hitch and towing vehicle, either two or four adjustable feet may be needed, or none at all. (See POLARO® customer pictures)