The SuperVario® can be mounted on the front or rear of all vehicles. There are mounting drill holes on the rear and bottom of the frame.
For all add-on components, a screw set for fixing them in place is standard.
As mounting supports, we offer the following mounting options:
|
3-point linkage hitch mounting support
The 3-point linkage hitch is fixed in place with four screws. The spreader can thus be effortlessly mounted onto the 3-point linkage hitch and removed again without any tools. |
 |
KAT 0, KAT I, KAT II three-point linkage
This is used for mounting the hydraulics to the upper and lower links.
It can be mounted in the front or rear.
Dimensions:
KAT 0: 530 mm
KAT I: 683 mm
KAT II: 825 mm
|
 |
Standard cultivator support
With this support, the SuperVario® is built onto a cultivator for the rational spreading of catch crops. It is fixed in place with four screws.
When spreading catch crops, we recommend mounting the spreader directly onto the soil-tilling implement. It should be mounted such that the spreading material falls into the rollers or the freshly tilled soil after the device.
|
 |
Cultivator support for 3-point linkage hitch
In combination with the 3-point linkage hitch mounting support, this support provides for maximum comfort while spreading. No tools are necessary to switch between mounting on the cultivator and in the front. |
 |
Front towing hitch support
This universal support is stuck into the front towing hitch. The bolt diameter measures 28 and 32 mm, respectively, as a standard (over thrust sleeve). The support is stabilised via the lateral angle and braced on the swivel feet with adjustingscrews.
(See POLARO® customer pictures) |
 |
Adjustable feet for fixing onto the front towing hitch support
Depending on the form of the towing hitch and form of the towing vehicle, either two or four adjustable feet may be needed, or none at all.
(See POLARO® customer pictures)
|
 |
|
Pick-up support
The height of the pick-up support is adjustable. The distance from the tailgate upper edge to the upper edge of the hitch ball is adjustable from 590 to 780 mm.
Vehicles checked so far:
Ford Ranger 700 mm, Nissan Narara 760 mm, Isuzu/Opel Campo Sports Cab 735 mm, Mitsubishi L200 735 mm, Dodge RAM 740 mm (hitch far behind), Landrover 830 mm (is too big)
|
 |
ATV/Quad support "on carrier"
The quad support is screwed onto the grill of the ATV, without any tools, on four corners via the lower short counterplates. The stay bolts included fit for supporting the spreader. This is the standard support for spreading slug pellets with an ATV or quad.
|
 |
Spare tyre holder
The spare tyre holder is intended for attaching the spreader to off-road vehicles that normally have a replacement tyre hanging on the rear door. A hole is drilled at the factory for this purpose. Please drill two others according to the hole locations of your vehicle. The four drilled holes for mounting the spreader are already provided for at the factory. |
 |
|
